The next step is a prompt to specify the location of the driver.Here it is necessary to specify that the source for the USB driver should not be ascertained automatically. The operating system starts an installation wizard that performs the installation, which is automatic.Initial installation of the USB driver can take some time and goes through the following steps: Moreover, the software for the virtual COM interface must be installed and set on the PC. This driver provides the interface between the USB interface and the operating system (Windows). If a SSW5/USB is being connected to the PC for the first time, the operating system will try to install a suitable driver. Use of the SSW5/USB with visualization systems that can be connected to the S5 CPU is also possible.Ĭonnections S5-PLC interface 15-way Sub-D connector It can then be used by programming software, such as Siemens Step 5 Version 7.2x, Deltalogic Accon programming software or other programming systems for the Simatic S5. For PCs that do not have a serial interface, the SSW5/USB cable can connect to the PLC via a virtual COM port.Ī virtual COM port is set up during installation of the SSW5/USB. The SSW5/USB converter cable is for connection of a Simatic S5 CPU to a PC with a USB interface.
0 kommentar(er)
